PRODUCTS Safety Relief Valves Pressure Relief Valves Gauges, Probes, Plugs, Calibration and Repairs Control Valves Weather Cap Girard Vents Surplus and Reconditioned Valves
All Categories > Girard Vents > MC 307 Pressure Relief Vent > View Items  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

MC 307 Pressure Relief Vent

Check up to five results to perform an action.

Function
The MC 307 Pressure Relief Vent is a stainless steel, pressure actuated unit that is engineered to limit excessive internal pressure to 130 percent of tank design. The standard model vent set at 25 PSIG will exhaust 26,700 SCFH at 32.5 PSIG and conforms to the emergency venting requirement code for MC 307 tanks having a total exposed surface area up to 700 square feet.

The stainless steel valve seat is equipped with a replaceable Tef-O-Sil "O-Ring."

The unit doubles as an unloading device, since the valve body is tapped 3/4" N.P.T. to accommodate the addition of inlet fittings for air unloading of transports. Provision is also made for a pressure gauge to be attached to the vent body. An optional incorporation of a small vacuum section in the valve seat is also available upon request. It should be noted that this section, due to its limited size, may not be adequate enough to prohibit tank implosion. For additional vacuum protection, refer to "Girard Magnetic Vacuum Breakers" for tank transports.

The entire vent is designed to be easily removed from the tank vehicle for inspection and/or cleaning.




Compare Items
   
  Results 1 - 4 of 4 Unit of Measure: Imperial Metric Both 1 

Item #

Item Description

O.D.

Weight

MC-307BT Vent with a 3" swivel nut. Mounts on a 3" nipple and seals against a solid Teflon® gasket. 4 7/8 in 5 lb. - 8 oz. without accessories
7 lb. with accessories
MC-307ST Stub end vent. Lower housing terminates in a straight stub end. Welds to the dome cover. 3 in 4 lb., 2 oz. without accessories
5 lb., 10 oz with accessories
MC-307MT Stub end vent. Lower housing terminates in a straight stub end. Welds to the dome cover. but the stub end is on an 18 degree angle to conform to the curvature of the dome cover. Note: 3/4" & 1/4" N.P.T. tap are not available in this style. 3 in 4 lb., 2 oz. without accessories
5 lb., 10 oz with accessories
MC-307FT Vent with a 3" TTMA drilled tank truck flange. Mounts to a 3" TTMA drilled companion flange on the transport. Supplied with a Teflon® envelope flange gasket. 6 1/4 in 4 lb., 2 oz. without accessories
5 lb., 10 oz with accessories
  Results 1 - 4 of 4 1 
Site created by ThomasNet Web Solutions
Pacific Industrial Service Inc. | On Call 24 hours a day, 7 days a week